xiros® radial deep groove ball bearing xirodur® B180 with J3 cage material, one-sided shield, stainless steel balls

xirodur® B180 | The all-rounder

The widest range of polymer ball bearing applications is covered by xirodur® B180. This material is seen as an all-rounder. In addition to its high wear resistance, the material offers good chemical and medium temperature resistance. The mechanical specifications are a good combination of hardness and flexibility. This option is delivered in combination with a J3 cage.

Typical application areas:

• Automotive
• Packaging technology
• Roller bearing

When to use it?

• When I need a technical all-rounder
• If the application temperatures are between -40°C and +80°C

When not to use it?

• If application temperatures are permanently below -40°C or above +80°C ▷ xirodur® A500
• When high chemical resistance is required at temperatures up to +60°C ▷ xirodur® C160
• If antistatic conductivity is required ▷ xirodur® F180
• If the material has to meet USP Class VI and DIN EN ISO 10993 ▷ xirodur® MT180

Tolerances and measurement system:

the tolerances for the inner and outer diameter depend on the installation size. These are often approx. ±0.05mm to the nominal size. The bearing rings are usually injection moulded and naturally have a certain ovality. Therefore, the caliper is used to measure 90° to the injection point (if available) over the entire width of the bearing. The dimensions and tolerances are designed in such a way that they fulfil a slight press-fit by hand when using a H7 holder and h6 shaft. An additional locating spigot using a circlip (shaft) and snap ring (housing) is recommended to prevent axial displacement.

Installation recommendation:

1. Housing (tolerance H7)

2. Front (balls visible)

3. Rear (cage visible)

4. Press-fit the ball bearing, front side first

5. Install shaft (tolerance h6) with chamfer

6. A locating spigot must be provided